I hate making muslins. I really do. If I make a muslin out of an ugly fabric while only sewing up the seams to check for fit, I never get the desired outcome. I know my skill at fitting is not advanced, so I cannot tell from those kinds of garments where to adjust, unless it is something easy and obvious, like length. But I don’t have to make a muslin to check for length, I can just hold the paper pattern up to my body or use a measureing tape. What seems to happen is I will make a pattern (not a muslin) and during the course of wearing it, the tweaks and adjustments needed make themselves known to me. Does anyone else do it this way? Continue reading
I love the Green Winter Street dress that I made for the Pattern Review Surprise Sewing Bee last year! I feel like a million dollars in it. But, I don’t get to wear it often. It is a bit much for everyday, which is sad. So, I am paying homage to that dress by using the same fabric combo again in this version of the Seamwork magazine Aurora tank. It makes me think of the original dress, and that makes me happy.
Recap on the fabrics – a french terry-ish knit that was labeled “Juicy Couture” on the remnant table, and the leopard is a very fluid knit that is soft as a baby’s bottom. They are both fabulous fabrics! I wish I had more of both of them, but at least I have used them twice and have enjoyed them thoroughly.
I made this with the same adjustments as before but scooped out the armhole just a bit and it is now perfect.
Warning – this tutorial is a tricky move on the Aurora tank because of the gathers. If it was just a straight join it would be easy peasy. But there is much fiddling and working with it to get it all lined up and not puckered. I know that is why Colette did not recommend this method when writing the instructions. I’d guess it adds 15 or 20 minutes to the sewing time.
To join the shoulder straps cleanly, first sew the yoke pieces at the back neck and both armholes, right side to right side, following the pattern instructions. Leave the yoke inside out. Then stick a safety pin into the top of both the front pieces where you have already gathered and finished armhole and neckline edges. Use the safety pin to feed the front straight up into the inside out yoke, keeping the front piece as flat as possible. I recommend threading both through at the same time to ennsure they are both facing right side up and nothing gets twisted.
When it is up through the top of the each yoke strap, straighten the gathers. Take each side of the gathered piece and carefully place them tightly into the side of the strap opening. smoothing your gathers evenly across, then pin. My pins are crookedly shoving those corners tight against the edges.
Sew straight across the strap, perpendicular to the pins. I don’t trim my edges until I pull it out and see how everything lined up and how my gathers look. If it isn’t perfect you can always try again. Pull the front right out and take a look! It is like magic!
Now the join of the strap and the front are fully enclosed and are not going to flip out or ravel. I used this technique on all my Aurora tanks and I think it is such a nice touch.
Here is the first outfit I tried with my new leopard Aurora tank– I decided the greens didn’t match so I changed, but I love the vibe of the maxi skirt and the top. Maybe I should make a skirt that will match?